7 COMMAND CENTER ADMINISTRATOR MODE
294 Setting up User Management
5
Select the LDAP server to be used for authentication and select the type of the LDAP
server. Then click [Next].
Windows Server — Select this when LDAP is running on a Windows server.
LDAP Server (Other than Windows Server) — Select this when the LDAP is on running the server other than a
Windows server. When this is selected, you have to specify the attribute type of ‘User Name’.
The LDAP server to be used for authentication must be configured in the [Directory Service] submenu in the
[Maintenance] menu.
P.203 “Managing directory service”
6
Specify how the From Address is set for Scan to Email.
Setting Address is 'User Name + @ + Mail Domain Name' — Select this to set the From Address as “User
Name@Mail Domain Name”, where “User Name” is the user name that is entered on the touch panel for
authentication, and “Mail Domain Name” is the domain name that is entered in the [Mail Domain Name] box.
When this is selected, enter the domain name in the [Mail Domain Name] box.
Setting Address is searching from 'User Name' of LDAP — Select this to set the From Address as the email
address found in the LDAP server.
When this is selected, this equipment will search for the user name, which is entered on the touch panel for
authentication, from the records of the attribute type in the LDAP server that you specify in the [LDAP Server] box
and [Attribute type of ‘User Name’] box.
If the user name is found, this equipment sets the From Address as the email address of the user name registered
in the LDAP server.
If the user name is not found in the LDAP server, this equipment sets the From Address as the “User Name@Mail
Domain Name”, where “User Name” is the user name that is entered on the touch panel for authentication, and
“Mail Domain Name” is the domain name that is entered in the [Mail Domain Name] box.
When this is selected, select the LDAP server in the [LDAP Server] box, enter the attribute type to search the user
name in the [Attribute type of ‘User Name’] box, and the domain name that is used when the user name is not
found in the [Mail Domain Name] box.
From Address is acquired from Email setting — Select this to set the From Address as the email address set in
the Email setting.
From Address cannot be edited in Scan to Email — Select this box if you do not want to allow users to edit the
From Address.
Setting Name is 'Account Name of From Address + From Name of Email Setting' — Select this check box to
set the name of an Email sender in a format 'Account Name + (space) + From Name of Email Setting'. A character
string before "@" in the sender's address (From Address) comes at 'Account Name'. A name displayed in [From
Name] of the [Email] submenu of the [Setup] menu on the [Administration] tab page comes at 'From Name of Email
Setting'.
To Next Page
Loading...
