8.OPTION SETUPS
Setting up IP Security Function 311
8 OPTION SETUPS
6
Click [Previous] to close the Security Service page.
7
Click [Save] on the Network submenu page.
Installing IPsec certificate automatically
1
Access the COMMAND CENTER administrator mode.
P.100 “Accessing COMMAND CENTER Administrator Mode”
2
Click [Setup], and then [Network].
P.107 “Setting up Network settings”
3
Click a link on the [Network] submenu or scroll down the menu and click [Security
Service].
The Security Service page is displayed.
4
Enter the items below, and then click [Request] in [Certificate for IP SEC].
CA Server address — Enter the IP address or FQDN of CA server within 128 characters.
MFP's Address in Common Name in the Certificate — Select whether you use the IP address or FQDN as the
address of this equipment to be entered in the [Common Name] box of the certificate.
Timeout — Enter timeout period for quitting communication when no response is received from CA server.
CA Challenge — Enter the CA challenge.
If FQDN is used in [CA Server address], you need to configure DNS server and enable DNS settings.
If [FQDN] is selected in [MFP’s Address in Common Name in the Certificate], the IP address of this
equipment must be registered into DNS server.
A server certificate is installed.
If you want to enable CRL Verification, go to the next step. If not, go to step 6.
To Next Page
Loading...
