LELY Attis PT 130

To Next Page

To Previous Page

3.11 Stop wrapping........................................................................................................................ 3-30

4. Operation adjustments...................................................................................................................... 4-1

4.1 Adjust the height of the drawbar pull eye................................................................................. 4-1

4.2 Adjust the film holder for other film roll sizes............................................................................4-2

4.3 Adjust the bearings adjusting plate.......................................................................................... 4-4

4.4 Adjust the film stretch...............................................................................................................4-5

4.5 Adjust the bale end-tipper........................................................................................................ 4-7

4.6 Program Settings..................................................................................................................... 4-8

4.6.1 Determine the number of wraps...............................................................................................4-8

5. Maintenance........................................................................................................................................5-1

5.1 Scheduled maintenance...........................................................................................................5-1

5.1.1 Maintenance after the first 5 working hours............................................................................. 5-1

5.1.2 Maintenance after operation.................................................................................................... 5-1

5.1.3 Maintenance every 50 working hours...................................................................................... 5-1

5.1.4 Maintenance every 100 working hours.................................................................................... 5-1

5.1.5 Maintenance every month........................................................................................................5-1

5.1.6 Maintenance every 5 year........................................................................................................5-1

5.1.7 Maintenance before prolonged storage................................................................................... 5-1

5.2 Preventive maintenance...........................................................................................................5-3

5.2.1 Clean the Attis..........................................................................................................................5-3

5.2.2 Lubricate the drive chain of the wrapping table rollers.............................................................5-8

5.2.3 Adjust the chain tension...........................................................................................................5-9

5.2.4 Verify the oil pressure in the accumulator..............................................................................5-10

5.3 Corrective maintenance......................................................................................................... 5-11

5.3.1 Replace the knife of the film cutter.........................................................................................5-11

6. Troubleshooting................................................................................................................................. 6-1

6.1 Error Messages........................................................................................................................6-1

6.1.1 Rotation speed too high........................................................................................................... 6-1

7. Diagrams and tables.......................................................................................................................... 7-1

7.1 Bolt and nut torque table.......................................................................................................... 7-1

7.2 Hydraulic diagram.................................................................................................................... 7-2

7.3 Quick referencecharts.............................................................................................................. 7-4

7.3.1 Default menu............................................................................................................................7-4

7.3.2 CAL.2 menu............................................................................................................................. 7-5

7.3.3 CAL.3 menu............................................................................................................................. 7-6

8. Specifications..................................................................................................................................... 8-1

8.1 Attis PT 130 Specifications...................................................................................................... 8-1

Table of Contents

W-H003.1403EN