4. OPERATION ADJUSTMENTS
Make sure that the PTO shaft is disengaged and the tractor engine is
switched off before adjustments are made.
4.1 Adjust the height of the drawbar pull eye
Always stop the tractor engine, remove the ignition key and wait until
all moving parts have stopped.
1. Remove the two bolts from the drawbar pull eye.
2. Adjust the drawbar pull eye to the applicable position, so that the
wrapping table is level when the Attis is connected to the tractor.
If necessary, turn the drawbar pull eye upside down to have more
positions.
3. Install the two bolts and tighten the nuts.
Figure 24. Adjust the height of the drawbar pull eye
WARNING
WARNING
Operation adjustments 4-1
W-H003.1403EN
To Next Page
Loading...
