3.9.1 Auto mode
Make sure no persons are within a 10 m (11 yd) radius of the Attis
during operation.
Do not operate the machine on a terrain with a slope of more than than
8°.
A load on the wrapping table or loading arm of the Attis may influence the
maneuverability of the tractor.
Always unload the bale transversal to the slope if you want to unload
on a sloping terrain.
Procedure
1. Make sure the film is attached to the clip or the film cutter.
2. Make sure the Attis is in the working position. (page 3‑18)
3. Make sure the correct number of wraps is set.
3. Set the machine in automatic mode.
◄ 00.00
▼
Verify if the E-link is set on automatic mode.
5. Lower the loading arm to the ground position.
down
6. Drive the tractor slowly towards a bale and make sure the
fork of the loading arm is in a straight line with the bale.
7. Drive the tractor until the bale is completely in the fork of the
loading arm and, then stop the tractor.
8. Lift the loading arm until the bale is loaded on the wrapping
table.
up
9. Lower the loading arm to the bottom position
down
10. Start the wrapping process.
When the required number of wraps is reached, the wrapping
table moves to the unloading position.
down
app
3 sec
Wait till the wrapping table is in the unloading position
CAUTION
WARNING
CAUTION
WARNING
3-22 Operation
W-H003.1403EN
To Next Page
Loading...
Need help?
General
