3.9 Start wrapping
Procedure
1. Pull the foil from the film roll and tie the foil to the eye bracket on the
frame (Figure 19, page 3‑21).
2. Verify the setting of the adjustments before wrapping and after
replacement or maintenance to the Attis:
• Determine the number of wraps (page 4‑8),
• Adjust the descending speed of the discharge table,
• Adjust the Attis for film holder sizes (page 4‑2)
• Adjust the Attis for bale sizes,
• Adjust the film stretch (page 4‑5),
• Program settings (page 4‑8).
1. Film roll - 2. Film - 3. Eye bracket
Figure 19. Tie the foil
Operation
3-21
W-H003.1403EN
To Next Page
Loading...
