3.4 Disconnect the Attis from the tractor
Always position the tractor on solid ground before you disconnect the
Attis from the tractor.
Make sure there are no persons near the Attis when you disconnect it
from the tractor.
Always switch off the tractor engine and remove the ignition key before
you leave the tractor cab.
Procedure
1. Move the right transport wheel to the transport position (page 3‑14).
2. Depressurise the tractor hydraulic system.
3. Remove the wheel wedges from the support and install them behind
the transport wheels.
4. Move the parking jack to the bottom position and lock it.
Turn the winding handle of the parking jack till the tension on the pull
eye is released.
5. Disconnect the hydraulic hoses from the tractor hydraulic system.
6. Install the dust caps on the hydraulic hoses.
7. Disconnect the lighting electrical cable from the tractor.
8. Disconnect the junction box electrical cable from the E‑link manual
controller.
9. Disconnect the safety towing chain to the towed vehicle and towing
vehicle, if available.
10. Unlock and remove the pin of the coupling system to disconnect the
Attis from the tractor.
11. Remove the tractor from the Attis.
WARNING
Operation 3-13
W-H003.1403EN
To Next Page
Loading...
Need help?
General
