LELY Attis PT 130 - Default Chapter; Table of Contents

Table of Contents
1. Introduction.........................................................................................................................................1-1
1.1 Optional extras......................................................................................................................... 1-3
1.1.1 Extension kit for 500 mm film...................................................................................................1-3
1.1.2 Safety towing chain..................................................................................................................1-4
1.1.3 Suction cup.............................................................................................................................. 1-5
1.1.4 Flow control unit.......................................................................................................................1-6
1.1.5 Battery extension cable set......................................................................................................1-7
1.1.6 Bale end-tipper.........................................................................................................................1-8
1.1.7 Foot plate................................................................................................................................. 1-9
2. Safety...................................................................................................................................................2-1
2.1 Signal words.............................................................................................................................2-1
2.2 Safety instructions....................................................................................................................2-1
2.2.1 Safety instructions....................................................................................................................2-1
2.2.2 Hydraulic safety instructions.................................................................................................... 2-2
2.3 Explanation of the safety decals.............................................................................................. 2-3
2.4 Explanation of remaining decals.............................................................................................. 2-4
2.5 Position of the decals............................................................................................................... 2-5
2.6 Explanation of the operation instructions................................................................................. 2-6
3. Operation.............................................................................................................................................3-1
3.1 Hydraulic control panel.............................................................................................................3-1
3.2 E-Link Manual Controller..........................................................................................................3-3
3.2.1 Interface structure.................................................................................................................... 3-5
3.2.2 Start up screens.......................................................................................................................3-6
3.2.3 Main menu............................................................................................................................... 3-6
3.2.4 Second calibration menu (CAL.2)............................................................................................ 3-9
3.2.5 Third calibration menu (CAL.3).............................................................................................. 3-11
3.3 Connect to the tractor.............................................................................................................3-12
3.4 Disconnect the Attis from the tractor...................................................................................... 3-13
3.5 Move the Attis to the transport position..................................................................................3-14
3.6 Move the Attis to the working position....................................................................................3-18
3.7 Move the Attis to the maintenance position........................................................................... 3-19
3.8 Process overview................................................................................................................... 3-20
3.9 Start wrapping........................................................................................................................ 3-21
3.9.1 Auto mode..............................................................................................................................3-22
3.9.2 Manual mode......................................................................................................................... 3-26
3.10 Replace a film roll...................................................................................................................3-28
Table of Contents
v
W-H003.1403EN