3.9.2 Manual mode
Make sure no persons are within a 10 m (11 yd) radius of the Attis
during operation.
Do not operate the machine on a terrain with a slope of more than than
8°.
A load on the wrapping table or loading arm of the Attis may influence the
maneuverability of the tractor.
Always unload the bale transversal to the slope if you want to unload
on a sloping terrain.
The manual mode is used as an escape to change the settings in the
automatic mode. The following operation tables describe the individual
changes in the manual mode.
Change to manual mode
1. Set the machine in manual mode.
00.00
◄ ▼
Verify if the machine is set in manual mode.
2. Make sure the correct number of wraps is set.
3. If necessary adjust the manual wrapping settings.
Start wrapping
1. Wrapping process
a. Start wrapping.
down
b. Stop wrapping.
When the wrapping number is reached the machine stops
automatically.
down
Reverse the wrapping table
1. Rotate the wrapping table reverse
Open the film cutter
1. Opens the film cutter, if two wrapping rotations are made.
WARNING
CAUTION
WARNING
3-26 Operation
W-H003.1403EN
To Next Page
Loading...
Need help?
General
