Table 1. Server Specifications (continued)
Specification
Description
Memory
See “Memory module installation order” in Setup Guide for detailed information
about memory configuration and setup.
• Slots: 4 DIMM slots
• Minimum: 8 GB (1 x 8GB RDIMM)
• Maximum: 256 GB (4 x 64GB LRDIMM)
• Type:
– PC4-21300 (single-rank, dual-rank), 2666 MT/s, error correcting code (ECC),
double-data-rate 4 (DDR4) registered DIMM (RDIMM)
– PC4-21300 (quad-rank), 2666 MT/s, error correcting code (ECC), double-data-
rate 4 (DDR4) load reduced DIMM (LRDIMM)
Note: For a list of supported processors, see
https://serverproven.lenovo.com/server/
se350
.
M.2 drive M.2 boot adapter
• Supports up to two identical M.2 SATA drives
• Supports three different physical sizes of M.2 drives:
– 42 mm (2242)
– 60 mm (2260)
– 80 mm (2280)
M.2 data adapter
• PCIe and M.2 riser assembly:
– Supports up to four M.2 SATA/NVMe drives
• M.2 riser assembly
– Supports up to eight M.2 NVMe drives
– Supports up to four NVMe and four SATA drives
• Supports four different physical sizes of M.2 drives:
– 42 mm (2242)
– 60 mm (2260)
– 80 mm (2280)
– 110 mm (22110)
Notes:
• M.2 drives installed on boot adapter and on data adapter are not swappable.
• M.2 connector type: socket 3 (M key)
• Mixing SATA drives and NVMe drives in the same M.2 SATA/NVMe 4-bay data
adapter is not supported.
PCIe riser assembly PCIe and M.2 riser assembly:
• Slot 6: PCI Express 3.0 x16, (supports <75W, low profile, half-height, half-length
PCIe adapter)
Chapter 1. Introduction 3
To Next Page
Loading...
