Figure 13. System-board connectors
Table 12. System-board connectors
1 Front operator panel connector 8 Lock switch connector
2 3V Battery (CR2032)
9 Intrusion switch connector
3 Fan 1 connector 10 Riser connector
4 Fan 2 connector
11 SATA Cable connector
5 Fan 3 connector 12 TPM connector
6 M.2 boot adapter connector
13 LOM module connector
7 Power distribution module connector
LOM packages
The following illustrations show the wireless enabled LOM package, 10G SFP+ LOM package, and 10G
BASE-T LOM Package.
Depending on the server configuration, connect one of the LOM packages to the LOM module connector on
the system board (see “System-board connectors” on page 23).
Wireless enabled LOM package
Wireless enabled LOM package enables the wireless function of the server. The connector on the package is
designed for M.2 WLAN/LTE wireless adapter. There are two types of the wireless adapter, both are installed
in the same method. For more information, see
“Install the M.2 WLAN/LTE wireless adapter” on page 42.
24
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
