Lenovo ThinkSystem SE350 - Node Replacement; Remove a Node

1. Install the node if needed (see “Install a node” on page 101).
2. Reconnect power cords and all external cables.
Node replacement
Use this information to remove and install a node.
Remove a node
Use this information to remove a node.
Before you remove a node, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
To remove a node, complete the following steps:
Step 1. To remove the node from the enclosure, complete the following steps.
a. Remove the five screws, and loosen the two thumb screws of the shipping bracket.
Figure 98. Node removal
b. Remove the shipping bracket from the enclosure.
98
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual