Figure 52. Fan installation
Table 23. Fan installation
1 Round pin 2 Fan cable
Step 1. Align the fan with the slot in the fan cage; then, place the fan into the slot. Make sure the fan cable
goes in the cable slot, under the round pin as shown.
Step 2. Connect the fan cable to the connector by pressing it down until it clicks.
After you install a fan, complete the following steps:
1. Reinstall the air baffle if it was removed (see
“Install the air baffle” on page 51).
2. Install the node if needed (see
“Install a node” on page 101).
3. Reconnect power cords and all external cables.
Front operator panel replacement
Use this procedure to remove or install the front operator panel.
Remove the front operator panel
Use this information to remove the front operator panel .
Before you remove the front operator panel , complete the following steps:
1. Read the following sections to ensure that you work safely.
Chapter 3. Hardware replacement procedures 67
To Next Page
Loading...
