Figure 61. Intrusion switch installation
After you install the intrusion switch, complete the following steps:
1. Install the node if needed (see
“Install a node” on page 101).
2. Reconnect power cords and all external cables.
Lock position switch replacement
Use the following information to remove and install the lock position switch.
Remove the lock position switch
Use this information to remove the lock position switch.
To avoid possible danger, read and follow the following safety information.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
S009
CAUTION:
Chapter 3. Hardware replacement procedures 75
To Next Page
Loading...
