2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Remove the node from the enclosure if needed (see
“Remove a node” on page 98).
4. Remove the air baffle (see
“Remove the air baffle” on page 50).
To remove a fan, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Figure 51. Fan removal
Step 1. Press and hold the fan cable latch.
Step 2. Disconnect the cable from the connector.
Step 3. Push the fan up from the bottom of the node and lift it out of the fan cage.
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install a fan
Use this information to install a fan.
To avoid possible danger, read and follow the following safety information.
Chapter 3. Hardware replacement procedures 65
To Next Page
Loading...
