Figure 31. M.2 data adapter installation
Step 3. Insert the bezels to the riser assembly on the both sides and install the six screws as shown.
Note: The color and the size of the screws on each side are different, make sure to install the short
ones one the left and long ones on the right.
Figure 32. M.2 data adapter installation
After you install a M.2 data adapter, complete the following steps:
1. Install the PCIe riser assembly (see
“Install the PCIe riser assembly” on page 106 for instructions).
2. Install the node if needed (see
“Install a node” on page 101).
3. Reconnect power cords and all external cables.
Remove the PCIe adapter
Use this information to remove the PCIe adapter.
Chapter 3. Hardware replacement procedures 47
To Next Page
Loading...
