Install the PCIe riser assembly
Use this information to install the PCIe riser assembly.
To avoid possible danger, read and follow the following safety statement.
• S012
CAUTION:
Hot surface nearby.
Before you install the PCIe riser assembly, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
3. Install the required adapters.
4. Remove the filler if it is installed.
a. Remove the three screws.
b. Grasp the filler by its edges and carefully lift it out of the server.
Figure 110. Filler removal
To install the PCIe riser cage, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
106
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
