Figure 7. Fillers
Table 6. Fillers
1 Antenna port filler (x2 or not available, depending on
the model)
4 SFP Ethernet connector filler (x2 or x4, depending on
the model)
2 VGA filler 5 Ethernet connector filler (x3 or x4, depending on the
model)
3 Mini USB filler 6 USB filler x2
Front operator panel
The front operation information panel of the server provides controls, connectors, and LEDs. The front
operator panel varies by model.
Figure 8. Front operator panel
Table 7. Front operator panel controls and indicators
1 Power button/LED (green) 4 Wireless enabled LOM package reset button
2 Identification button/LED (blue)
5 NMI button
3 System-error LED (yellow) 6 XClarity Controller mini USB connector
1 Power button/LED (green): Press this button to turn the server on and off manually. The states of the
power LED are as follows:
Off: Power is not present or the power adapter, or the LED itself has failed.
Flashing rapidly (4 times per second): The server is turned off and is not ready to be turned on. The
power button is disabled. This will last approximately 5 to 10 seconds.
Flashing slowly (once per second): The server is turned off and is ready to be turned on. You can press
the power button to turn on the server.
On: The server is turned on.
20
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
