Lenovo ThinkSystem SE350 - M.2 Drive on an M.2 Data Adapter Replacement; Remove an M.2 Drive from an M.2 Data; Adapter

Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Step 1. With washers between the antenna and the server, rotate the antenna clockwise to install it to the
server.
Note: The suggested fastening torque is 3.5 Kgf-cm.
Figure 67. LTE/WLAN Antenna installation
Table 25. LTE/WLAN Antenna
1 Washers
After you install a LTE/WLAN Antenna, complete the following steps:
1. Install the node if needed (see
“Install a node” on page 101).
2. Reconnect power cords and all external cables.
M.2 drive on an M.2 data adapter replacement
Use the following information to remove and install an M.2 drive on an M.2 data adapter.
Remove an M.2 drive from an M.2 data adapter
Use this information to remove an M.2 drive from an M.2 data adapter.
Before you remove an M.2 drive from an M.2 data adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16).
3. Remove the node from the enclosure if needed (see “Remove a node” on page 98).
80
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual