Lenovo ThinkSystem SE350 - Install the Top Cover

• “Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
To remove the top cover, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Figure 150. Top cover removal
Step 1. Press on the release button and the push point at the same time; then, slide the cover toward the
rear of the server.
Step 2. Lift the top cover away from the server.
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install the top cover
Use this information to install the top cover.
To avoid possible danger, read and follow the following safety information.
S012
CAUTION:
Hot surface nearby.
S014
Chapter 3. Hardware replacement procedures 141