Lenovo ThinkSystem SE350 - Page 82

• “Safety” on page iii
• “Installation Guidelines” on page 37
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 16
).
To install the intrusion switch cable, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
DkEpH4SzvKZck4f6rVRzUE
.
Insert the intrusion switch cable through the hole on the carrier.
Figure 60. Intrusion switch cable installation
Step 1. Lower the intrusion switch carrier into the chassis and press the intrusion switch carrier down until
it is securely seated.
Step 2. Fasten the two screws.
Step 3. Connect the cable to the connector and press it down until it clicks.
74
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual