Attention: If the node is to be installed in an E1 Enclosure (1U 2-node), change the vital product
data (VPD) for proper operation. See
“Change the VPD for E1 Enclosure configuration (trained
technician only)” on page 139
.
a. Determine the node bay to install the node.
b. Insert the node into the node bay until it stops.
• E1 Enclosure (1U 2-node)
Figure 104. Node installation
• E2 Enclosure (2U 2-node)
Figure 105. Node installation
c. Align and insert the shipping bracket onto the front of the enclosure.
102
ThinkSystem SE350 and ThinkSystem SE350 Enclosures Maintenance Manual
To Next Page
Loading...
