RTW: Memory mapped space start: 0x4040000000 len:00010000 flags:00140204, after map:0xffff00000e2d0000
RTW: CHIP TYPE: RTL8822BE
RTW: Bus master is enabled. usPciCommand=7
RTW: PCIe Header Offset =70
RTW: PCIe Capability =2
Link Control Register =40
RTW: Clock Request =0
Sever could not be set as WLAN AP mode
Complete the following steps until the problem is resolved:
1. Log into Lenovo XClarity Controller (change password for the first-time log in). Enable Wi-Fi
Connectivity and input the information of AP mode.
Note: Server supports WPA2 only.
Figure 159. Network setting
2. If the server still cannot work in AP mode, repeat step one or check the AP mode status by using the
command through OpenWRT:sudo uci show wireless
For example:
oper@OpenWrt:/tmp$ sudo uci show wireless
wireless.radio0=wifi-device
wireless.radio0.type='mac80211'
wireless.radio0.channel='11'
wireless.radio0.hwmode='11n'
wireless.radio0.path='soc/3400000.pcie/pci0000:00/0000:00:00.0/0000:01:00.0'
wireless.radio0.disabled='0'
wireless.radio0.htmode='HT40'
wireless.radio0.country='TW'
wireless.default_radio0=wifi-iface
wireless.default_radio0.device='radio0'
wireless.default_radio0.network='wifi_lan_ap'
wireless.default_radio0.mode='ap'
wireless.default_radio0.ssid=' SE350_ap3'
wireless.default_radio0.encryption='psk2'
Chapter 4. Problem determination 163
To Next Page
Loading...
