Refer to the following rear view for different server models:
•
“Server model with three PCIe slots” on page 17
• “Server model with two PCIe slots” on page 17
Server model with three PCIe slots
The following illustration shows the rear view of server model with three PCIe slots. Depending on the model,
your server might look slightly different from the illustration below.
Figure 2. Rear view with 3 low profile PCIe adapters
Table 6. Components on the rear of the server
Callout Callout
1 PCIe slot 1 on riser 1 assembly 2 PCIe slot 2 on riser 1 assembly
3 PCIe slot 3 on riser 2 assembly 4 Power supply 2 (optional)
5 Power supply 1 6 NMI button
7 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs) 8 VGA connector
9 XClarity Controller network connector 10 Ethernet connectors on OCP 3.0 Ethernet adapter
(optional)
Note: For more information about each component, see
“Rear components overview” on page 19.
Server model with two PCIe slots
The following illustration shows the rear views of the server model with two PCIe slots. Depending on the
model, your server might look slightly different from the illustration below.
Figure 3. Rear view with 1 low profile PCIe adapter, 1 full height PCIe adapter, and 1 filler
Table 7. Components on the rear of the server
Callout Callout
1 PCIe slot 1 on riser 1 assembly 2 PCIe slot 2 on riser 1 assembly
3 Power supply 2 (optional)
4 Power supply 1
5 NMI button
6 VGA connector
Chapter 2. Server components 17
To Next Page
Loading...
