in the long run, the average bit rate will be very close to 2M.
This mode allows the most accurate storage estimations,
however, while planning the bandwidth, please consider the
occasional peaks of bit rate.
The user can define the quality with the numeric scale from 1 to
100. The default MJPEG quality is 60. The higher is the quality
level, the more bit rate the camera will use to achieve the target
quality. However, note that local Live View cannot display
streams other than H.264.
Under VBR mode, the bit rate will be floating while the video
quality will be stable and follows the quality standard set by the
user. The user can choose either “Hig
quality. The higher is the quality level, the more bit rate the
camera will use to achieve the target quality.
Under VBR mode it is possible to adjust the GOP length - that is
the occurrence rate of I-frames. By default, there is one I-frame
second. For example, in case of 30fps, there will be 1
I-frame and 29 P-frames every second by default. When the
GOP is changed- frameto“1 perI 5 seconds”, th
one I-frame, followed by 149 P-frames. In case of the static
scenes, long GOP can further minimize the bandwidth and
6. When done, click Save. The camera properties are saved and DSS-1000 restarts
the connection.
63
To Next Page
Loading...
Need help?
General
