Par S Strobe Adj
This setting adjusts the factory setting for the amount of time the strobe is sampled to determine that valid data is
available on the parallel port.
Each time the value is increased by one, the strobe is sampled 50 nanoseconds longer. Each time the value is decreased
by 1, the strobe is sampled 50 nanoseconds less than the default value. The range of values is between -4 and +6, in
increments of one. A value of zero indicates no change is made from the factory setting.
EP Setup
EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. Sometimes this is used to help
correct print quality problems.
To restore the EP defaults:
1 From the Diagnostics menu, navigate to:
EP Setup > EP Defaults
2 Select Restore to restore the default values, or press X to exit without changing the settings.
Fuser Temperature (Fuser Temp)
This setting adjusts the fuser temperature to solve problems with paper curl on low‑grade paper and/or melting of
letterheads on some papers.
To adjust this setting:
1 From the Diagnostics menu, navigate to:
EP Setup > Fuser Temp
2 Press OK or touch to save any changes.
Transfer Adjust
This setting controls the transfer roll algorithm.
To adjust this setting:
1 From the Diagnostics menu, navigate to:
EP Setup > Transfer Adjust
2 Press OK or touch to save any changes.
4514-6xx
Service menus
142
To Next Page
Loading...
