Action Yes No
Step 4
Check the fuser gear for damage or toner contamination.
Is it free of damage and contamination?
Replace the controller
board. See
“Controller
board removals” on
page 200.
Replace the fuser. See
“Fuser removal” on
page 263.
201 paper jams
[x]‑page jam, clear standard bin. [20y.xx]
1 Firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
2 From the printer control panel, press to clear the message and continue printing.
201 paper jam messages
Error code Description Action
201.01 Narrow media sensor is covered during warm up.
Input sensor is not covered.
Go to
“Sensor (narrow media) jam service check” on
page 56.
201.20 Took too long to ramp up auger motor. Go to
“Cartridge gearbox service check” on
page 102.
201.21 Stopped detecting pulses from auger motor's encoder
system.
Go to
“Cartridge gearbox service check” on
page 102.
201.22 Auger motor underspeed error. Go to
“Cartridge gearbox service check” on
page 102.
4514-6xx
Diagnostic information
55
To Next Page
Loading...
