Lexmark MS510 - The printer is not responding

Controller board shield removal (MS610de)
Note: This is not a FRU.
1 Remove the right cover. See “Right cover removal” on page 194.
2 Remove the four screws (A) securing the controller board shield.
A
Controller board removals
Note: Before replacing the controller board, export the eSF solutions and settings from the printer. For more
information, see
“Backing up eSF solutions and settings” on page 163.
Controller board removal (MS510dn and MS610dn)
1
Remove the right cover. See “Right cover removal” on page 194.
2 Disconnect all cables from the controller board.
4514-6xx
Repair information
200