Lexmark MS510 - Page 50

200 paper jam messages
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to
“Sensor (input) static jam service check” on
page 51.
200.02 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 52.
200.03 Page did not reach input sensor or was late reaching
input sensor, but was successfully picked from the
source.
Go to
“Sensor (input) early/late arriving service
check” on page 52.
200.05 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 52.
200.08 Page arrive at input senor at unexpected time. Go to
“Sensor (input) early/late arriving service
check” on page 52.
200.09 Printhead did not receive proper motor feedback to
start laser servo.
Go to
“Sensor (input) image jam service check” on
page 53.
200.10 Printhead motor not locked when media reaches the
input sensor.
Go to
“Sensor (input) image jam service check” on
page 53.
200.11 Printhead motor fell out of lock after page reaches the
input sensor.
Go to
“Sensor (input) image jam service check” on
page 53.
200.12 Printhead was not ready for media. Go to
“Sensor (input) image jam service check” on
page 53.
200.13 Media at input sensor is not the next media to be
imaged.
Go to
“Sensor (input) image jam service check” on
page 53.
200.14 Media reached the input sensor before EP was ready. Go to
“Sensor (input) image jam service check” on
page 53.
200.15 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 52.
200.16 Fuser motor stalled. Go to
“Main drive motor control jam service check”
on page 54.
200.21 No response from paper port driver while waiting for
the source to deactivate the Input Source Ready flag
to indicate it has initiated picking.
Go to
“Sensor (input) early/late arriving service
check” on page 52.
200.23 Laser servo never started due to potential conflict
with the transfer servo.
Go to
“Sensor (input) image jam service check” on
page 53.
200.24 Measured gap at input sensor too small to meet video
delivery requirements. (Not enough time since prior
image finished to start new image).
Go to
“Sensor (input) image jam service check” on
page 53.
200.25 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 52.
200.29 Printhead drive control out of range due to an
external event beyond what the control is designed
to handle.
Go to
“Sensor (input) image jam service check” on
page 53.
4514-6xx
Diagnostic information
50