9 Close the front door.
10 From the printer control panel, touch to clear the message and continue printing. For non‑touch‑screen printer
models, select Next >
> Clear the jam, press OK > .
200 paper jam messages
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to “Sensor (input) static jam service check” on
page 52.
200.02 Input sensor covered too quickly. Go to “Sensor (input) early/late arriving service
check” on page 53.
200.03 Media did not reach input sensor from MPF.
200.05 Input sensor covered too long.
200.07 Input sensor failed to become uncovered from sheet
ahead.
200.08 Page arrive at input senor at unexpected time.
200.09 Printhead did not receive proper motor feedback to
start laser servo.
Go to “Sensor (input) image jam service check” on
page 54.
200.10 Printhead motor not locked when media reaches the
input sensor.
200.11 Printhead motor fell out of lock after page reaches the
input sensor.
200.12 Printhead was not ready for media.
200.13 Media at input sensor is not the next media to be
imaged.
200.14 Media reached the input sensor before EP was ready.
200.15 Image data did not start on time.
200.16 Fuser motor stalled. Go to “Main drive motor control jam service check”
on page 55.
200.19 Page that was successfully picked from option tray
never reached the input sensor.
Go to “Sensor (input) early/late arriving service
check” on page 53.
200.21 No response from paper port driver while waiting for
the source to deactivate the Input Source Ready flag
to indicate it has initiated picking.
7015
Diagnostic information
51
To Next Page
Loading...
