Error code Description Action
200.23 Laser servo never started due to potential conflict
with the transfer servo.
Go to “Sensor (input) image jam service check” on
page 54.
200.24 Measured gap at input sensor too small to meet video
delivery requirements. (Not enough time since prior
image finished to start new image).
200.29 Printhead drive control out of range due to an
external event beyond what the control is designed
to handle.
200.30 Invalid printhead NVRAM.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
Go to “Sensor (input) early/late arriving service
check” on page 53.
200.32 Detected cover switch bounce.
200.33 Input sensor covered too quickly.
200.38 Interpage servo gap smaller than expected for galvo
offset target evaluation.
Go to “Sensor (input) early/late arriving service
check” on page 53.
200.42 Rogue sheet at ACM sensor while flushing the paper
path prior to declaring tray 1 source empty.
200.44 Page from tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple pick
attempts. Page did make it out of the tray at least as
far as the ACM sensor.
200.45 During warm up flush, sheet detected too long over
input sensor.
Sensor (input) static jam service check
Action Yes No
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Go to step 2. Clear the paper path of
any media fragments.
Step 2
Check the jam access cover if it is blocking the input sensor.
Is it blocking the input sensor?
Replace the jam access
cover. See “Jam access
cover removal” on
page 264.
Go to step 3.
Step 3
Check the input sensor cable for proper connection.
Is it properly connected?
Go to step 4. Reseat the cable.
7015
Diagnostic information
52
To Next Page
Loading...
