Action Yes No
Step 6
Observe the location of the jammed paper.
Are the first page fed to the output bin, the second page jammed in the
rear door, and the third page jammed in the input tray?
Go to step 7. Replace the trailing
edge sensor. See
“Trailing edge sensor
removal” on page
282.
Step 7
Perform a tray 1 pick/lift motor gearbox service check. See “Tray 1 pick/
lift motor gearbox service check” on page 104.
Does the error remain?
Go to step 8. The problem is solved.
Step 8
Check the ACM assembly.
Is it free of wear or damage?
Go to step 9. Replace the ACM
assembly. See “ACM
assembly removal” on
page 288.
Step 9
Check the MPF gearbox
Is it free of wear or damage?
Go to step 10. Replace the MPF
gearbox. See “MPF
gearbox removal” on
page 215.
Step 10
Check the main drive gearbox
Is it free of wear or damage?
Go to step 11. Replace the main drive
gearbox. See“Main
drive gearbox
removal” on page
211.
Step 11
Does the error remain?
Contact the next level
of support.
The problem is solved.
Option tray jam service check
Action Yes No
Step 1
Restart the printer.
Does it fail to complete the POST sequence and display a 242.01 error?
Replace the option
tray.
Go to step 2.
Step 2
a POR into the Diagnostics menu and perform a feed test:
Diagnostics Menu > Input Tray Tests > Feed Test >
Select an option tray > Continuous
b Cancel the test after five pages.
Does the printer successfully feed the five pages into the output bin?
The problem is solved. Go to step 3.
Step 3
Does the printer display a 242.06 error?
Replace the ACM
assembly. See “ACM
assembly removal” on
page 335.
Go to step 4.
7015
Diagnostic information
70
To Next Page
Loading...
