Diagnostic information 2-35
7510
989.00
Service finisher
error
Stapler unit error The sensing area of the sensor (stapler unit motor
HP) inside the stapler unit assembly is not
interrupted within the specified timer after the
stapler unit motor starts moving to the home
position.
Refer to the Finisher Service Manual.
990.00
Service finisher
error
Sensor (stapler carriage HP)
late error
The sensing area of the sensor (stapler carriage
HP) is not interrupted within the specified time after
the stapler carriage starts moving to the home
position.
Refer to the Finisher Service Manual.
990.01
Service finisher
error
Sensor (stapler carriage HP)
lag error
The sensing area of the sensor (stapler carriage
HP) remains interrupted within the specified time
after the stapler carriage starts moving from the
home position.
Refer to the Finisher Service Manual.
991.00
Service finisher
error
Sensor (booklet front tamper
HP) late error
The sensing area of the sensor (booklet front
tamper HP) is not interrupted within the specified
time after the front booklet tamper starts moving to
the home position.
Refer to the Finisher Service Manual.
991.01
Service finisher
error
Sensor (booklet front tamper
HP) lag error
The sensing area of the sensor (booklet front
tamper HP) remains interrupted within the specified
time after the front booklet tamper starts moving
from the home position.
Refer to the Finisher Service Manual.
991.02
Service finisher
error
Sensor (booklet rear tamper
HP) late error
The sensing area of the sensor (booklet rear tamper
HP) is not interrupted within the specified time after
the rear booklet tamper starts moving to the home
position.
Refer to the Finisher Service Manual.
991.03
Service finisher
error
Sensor (booklet rear tamper
HP) lag error
The sensing area of the sensor (booklet rear tamper
HP) remains interrupted within the specified time
after the rear booklet tamper starts moving from the
home position.
Refer to the Finisher Service Manual.
991.04
Service finisher
error
Sensor (booklet end guide
HP) late error
The sensing area of the sensor (booklet end guide
HP) is not interrupted within the specified time after
the booklet end guide starts moving to the home
position.
Refer to the Finisher Service Manual.
991.05
Service finisher
error
Sensor (booklet end guide
HP) lag error
The sensing area of the sensor (booklet end guide
HP) remains interrupted within the specified time
after the booklet end guide starts moving from the
home position.
Refer to the Finisher Service Manual.
991.06
Service finisher
error
Sensor (booklet unit interlock)
error
The sensor (booklet unit interlock) detected that the
booklet maker was not completely inserted when
the finisher front door assembly was closed.
Refer to the Finisher Service Manual.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
