2-36 Service Manual
7510
991.07
Service finisher
error
Sensor (booklet compiler no
media) no media detected
The sensing area of the sensor (booklet compiler no
media) did not detect any media when the booklet
stapler motor was activated.
Refer to the Finisher Service Manual.
991.08
Service finisher
error
Sensor (booklet knife HP)
late error
The sensing area of the sensor (booklet knife HP) is
not interrupted within the specified time after the
booklet knife started moving to home position.
Refer to the Finisher Service Manual.
991.09
Service finisher
error
Sensor (booklet knife HP) lag
error
The sensing area of the sensor (booklet knife HP)
remains interrupted within the specified time after
the booklet knife started moving from home position.
Refer to the Finisher Service Manual.
991.10
Service finisher
error
Sensor (booklet knife folding)
late error
The sensing area of the sensor (booklet knife
folding) is not interrupted within the specified time
after the booklet knife solenoid was activated.
Refer to the Finisher Service Manual.
991.11
Service finisher
error
Booklet stapler error The booklet stapler unit has failed.
Refer to the Finisher Service Manual.
991.12
Service finisher
error
Communication error with
booklet controller card
assembly
A communication error has occurred with the
booklet controller card assembly and the finisher
controller card assembly.
Refer to the Finisher Service Manual.
991.13
Service finisher
error
Booklet unit maker error Booklet set recovery was detected too many times
for the same job. Perform a POR.
Refer to the Finisher Service Manual.
992.00
Service finisher
error
Sensor (de-curler clutch HP)
late error
The sensing area of the sensor (de-curler cam HP)
is not interrupted within the specified time after the
de-curler roll assembly (nip) starts moving to the
home position.
Refer to the Finisher Service Manual.
992.01
Service finisher
error
Sensor (de-curler clutch HP)
lag error
The sensing area of the sensor (de-curler cam HP)
remains interrupted within the specified time after
the de-curler roll assembly (nip) starts moving from
the home position.
Refer to the Finisher Service Manual.
Close cover F Bridge unit cover is open. The bridge unit assembly cover is open.
Refer to the Finisher Service Manual.
Close door A Printer left door open. The printer left door assembly is open, or the printer
left door closed actuator is damaged.
Go to “Printer left door open” on page 2-187.
Close door B Duplex left door assembly
open.
The Duplex left door assembly is open.
Go to “Duplex left door assembly open” on
page 2-181.
Close door C Printer left lower door
assembly open
The printer lower left door assembly is open.
Go to “Printer left lower door assembly open” on
page 2-188.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
