Lexmark X945 - Page 151

Diagnostic information 2-37
7510
Close door D 1TM, 3TM or TTM left door
assembly open
The 1TM, 3TM or TTM tray left door assembly is
open.
Go to “1TM, 3TM or TTM left door assembly
open” on page 2-180.
Close door E Printer front door assembly
open
Printer front door assembly is open.
Go to “Printer front door assembly open” on
page 2-186.
Close door G Finisher front door open. The finisher front door is open.
Refer to the Finisher Service Manual.
Close door J Transfer belt access door
open.
The transfer belt access door is open.
Go to “Transfer belt access door open” on
page 2-188.
Close
surface H
Eject cover open. The finisher eject cover is open.
Refer to the Finisher Service Manual.
Empty hole
punch box
Punch waste box full. The punch waste box is full.
Refer to the Finisher Service Manual.
Insert hole
punch box
Punch waste box missing. No punch waste box.
Refer to the Finisher Service Manual.
Load staples Staple cartridge empty. Staple cartridge empty.
Refer to the Finisher Service Manual.
Load tray x with
<media>
No media in the selected
media tray.
Media is not loaded in the tray.
Go to “No media in the selected media tray” on
page 2-183.
Remove paper
from bin 1
Finisher upper media bin full. Stacker set over count
The upper media bin has reached maximum
capacity.
Refer to the Finisher Service Manual.
Remove paper
from bin 2
Stacker media bin full (no
mix)
The stacker media bin has reached maximum
capacity (no mix).
Refer to the Finisher Service Manual.
Remove paper
from bin 2
Stacker media bin full (mix
size)
The stacker media bin has reached maximum
capacity (mix size).
Refer to the Finisher Service Manual.
Remove paper
from standard
output bin
Standard bin 1 full. Media in standard bin 1 is at maximum capacity.
Go to “Standard media bin full” on page 2-190.
Scanner ADF
cover open
ADF left cover assembly is
open
The ADF left cover assembly is open.
Go to “ADF left cover assembly is open” on
page 2-191.
Scanner
missing cable
unplugged
Scanner unit assembly not
detected
The scanner unit assembly is unplugged or missing.
Go to “Scanner unit assembly not detected” on
page 2-190
.
Error code or
message
Error contents Description/Action