Lexmark X945 - Page 361

Diagnostic aids 3-5
7510
Model Name See “Model Name” on page 3-19.
Configuration ID See “Configuration ID” on page 3-19.
EVENT LOG
Display Log See “Display the Event Log” on page 3-21.
Print Log See “Print the Event Log” on page 3-22.
Clear Log See “Clear the Event Log” on page 3-22.
SCANNER TESTS
ASIC Test See “ASIC Test” on page 3-23.
Feed Test See “Feed Test” on page 3-23.
Scanner Manual Registration See “Scanner Manual Registration” on page 3-24.
Sensor Tests See “Sensor Test (Scanner Tests)” on page 3-24.
Trans Belt Fail Clear
Trans Belt HP Fail Clear See “Trans Belt HP Fail Clear” on page 3-25.
Dev Unit Reset See “Dev Unit Reset” on page 3-25.
Y Channel
M Channel
C Channel
K Channel
Fuser Temp Fail Clear
Fuser Temp Fail Clear See “Fuser Temp Fail Clear” on page 3-25.
ATC SENSOR FAILURE CLEAR See “ATC SENSOR FAILURE CLEAR” on page 3-25.
Y Channel (925.00)
M Channel (925.01)
C Channel (925.02)
K Channel (925.03)
ENGINE ADJUST See “ENGINE ADJUST” on page 3-26.
PH ADJUST (registration)
ATC sensor Adjust Values
ATC Sensor Adjust Cycles
RegCon Adjust
Booklet Fold Adjust See “Booklet Fold Adjust” on page 3-29.
Booklet Tamper Shift Adj
Booklet Compile Position
Booklet 2-sheet
Booklet 15-sheet
Booklet Fold Pos Fine Adj
Booklet Staple Pos Fine Adj
Finisher Config See “Finisher Config” on page 3-29.
Exit Diagnostics Menu See “Exiting Diagnostics Menu” on page 3-34.