Page 20 / 89 Section 4. Operation
4.2.8. OUTPUT LOCK
A destination’s state can be locked; this feature prevents an accidental switching to the
locked destination in case of important signal. Locking a destination means, that no input
selection or muting can be executed on that particular destination. Destinations can be
independently locked or unlocked. Locking a destination does not affect other destinations.
View locked outputs in TAKE mode
Step 1. Press and release the Output Lock button.
Step 2. The Output Lock button starts to blink and all the buttons of any locked destinations
light up, and remain illuminated for three seconds.
Lock an output in TAKE mode
Step 1. Press and release the Output Lock button.
Step 2. Now the Output Lock button starts to blink and all the locked output’s buttons
illuminate green (view state).
Step 3. If no button is pressed for three seconds, the router returns to idle state.
Step 4. If an unlit output button is pressed, it starts to blink, to indicate that it is preselected
for output locking.
Step 5. Press and release TAKE button. The selected destinations are now locked.
Unlock an output in TAKE mode
Step 1. Press and release the Output Lock button.
Step 2. Now the Output Lock button starts to blink and all the locked output’s buttons
illuminate green (view state).
Step 3. If no button is pressed for three seconds, the router returns to idle state.
Step 4. If an illuminating output button is pressed, it goes off, to indicate that it is
preselected for unlocking.
Step 5. Press and release the TAKE button. The deselected destinations are now
unlocked.
View locked outputs in AUTOTAKE mode
In AUTOTAKE mode a destination is selected all the time. Therefore the currently selected
output and input buttons are illuminated. The Output Lock button illuminates regarding to
the lock state of the current output.
Viewing all locked outputs is not possible in AUTOTAKE mode, as pressing the Output
Lock button instantly locks or unlocks the current output.
Lock an output in AUTOTAKE mode
Step 1. Press and release the required destination button. Now the selected destination
button and the currently configured source button light up (view mode).
Step 2. Press and release the Output Lock button. Now the Output Lock button lights up in
red, and lock function is activated at once. No source can be changed at the locked
destination.
Unlock an output in AUTOTAKE mode
Step 1. Press and release the required destination button which was previously locked.
Now the selected destination button and the currently configured source button and
the Output Lock button light up.
Step 2. Press and release the Output Lock button (deselect). Now the Output Lock button
turns off, and the locking function has been cancelled.
To Next Page
Loading...
Need help?
General
