Page 48 / 89 Section 6. Web control – Using built-in website
6.4. Configuration menu
The network settings of the matrix are displayed under Configuration menu.
Figure 6-7. Configuration menu
Info: Factory default IP settings can be reloaded by the front panel buttons. See section 4.3.5
on page 22.
6.4.1. Automatic IP Address Configuration
The matrix switcher supports three of the most used automatic IP configuration protocols.
To assign IP address automatically
Step 1. Click on Configuration menu.
Step 2. Select Obtain IP address automatically.
Step 3. Enter the following (as necessary):
BOOTP: Select Enable to permit the Bootstrap Protocol (BOOTP) server to
assign the IP address from a pool of addresses automatically.
DHCP: Select Enable to permit the Dynamic Host Configuration Protocol
(DHCP) server to assign leased IP address to the matrix unit
automatically.
AutoIP: Select Enable to permit the matrix to generate an IP in the 169.254.x.x
address range with Class B subnet.
Info: Disabling BOOTP, DHCP, and AutoIP (all three checkboxes) is not advised as the only
available IP assignment method will then be ARP or serial port.
Step 4. When you are finished, click Apply Settings button.
Info: To continue using the built-in website, you have to type in the IP address in your browser.
To Next Page
Loading...
Need help?
General
