4 Operation
Special equipment
Switch off the truck and log off:
¾ Rotate the turning knob (6) anticlockwise to
the stop.
The engine is turned off.
NOTE
After a delay time (factory setting = 10 se-
conds) the red LED (1) lights up briefly, and
the green (2) and red (1) LEDs then flash for
approx. 3 seconds. During this period, the
truck can be started at any time. The LEDs
then go out, and the PIN is discarded. The
delay time can be set to between 10 seconds
and 10 minutes using the diagnostic device.
Please contact your authorised dealer.
Adjusting the driver’s seat with
rotating device
CAUTION
The driver’s seat must not rotate while the truck is
in use.
It should therefore be ensured that the rotating
device is locked.
The driver’s seat with rotating device offers
better rear visibility during reverse travel over
long distances.
When driving forwards over long distances, it
is recommended that you return the seat to the
straight-ahead position.
The rotating device is maintenance free.
88 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
