Linde H50D - Check the Forks and Fork Quick-Releases

5 Maintenance
Load lift system
3
4
d3921486
¾ Loosen lock nut (4). Adjust chain at adjust-
ment nut (3) of chain anchor.
The lower guide roller on the fork carriage may
only protrude max. 30 mm from the inner lift
mast guide rail.
¾ Tighten the locknut (4).
CAUTION
When extending the lift mast, it must not touch the
end stops.
Fully extend the lift mast and check clearance to
end stops.
Apply chain spray.
NOTE
In the case of trucks that are used in the food
production sector, chain spray should not be
used. Instead, use a low-viscosity oil licensed
for use in the food industry.
¾ Apply Linde chain spray to guide surfaces
and chain.
Check the forks and fork quick-
releases
¾ Check the forks for visible deformations,
wear and damages.
¾ Check the bolts of the fork stops and fork
quick-releases for correct seating and
damage.
¾ Replace any defective parts.
188 Operating Instructions – 394 807 10 01 EN – 07/2011