Operation 4
Special equipment
Linde Forklift Data Management
(LFM)
Truck data acquisition
The truck data acquisition (FDE) input device
(1) is located in the armrest console (3).
The input device has a 12-di
git keypad (2).
With the standard setting, a 5-digit PIN is
allocated to the respective driver to ensure that
the truck can only be operated by authorised
personnel.
The truck can only be started after entering this
PIN and possibly a status code (depending on
the setting).
NOTE
The PIN can be extended from 5 to 8 digits.
Before entering the PIN, please contact your
fleet manager to check the number of digits in
the PIN and to find out about the truck settings.
Status code
NOTE
The code indicates the status of the truck.
The following codes are available:
•
0
=TruckOK
•
1
= Request service (truck will not start)
•
2
= Request maintenance (truck starts)
•
3
= Problem with driving
•
4
= Problem with lifting
•
5
= Problem with steering
•
6
= Accident damage
•
7
= User-defined
•
8
= User-defined
•
9
= User-defined
The status messages
7
,
8
and
9
can be
defined individually by the user. Please
contact your fleet manager to find out the
definition of these status messages.
Operating Instructions – 394 807 10 01 EN – 07/2011 81
To Next Page
Loading...
