Operation 4
Loading / Transporting
1
2
3
4
5
d3921468
¾ Turn the hexagon head screw (3) on the
hose pulley (1) in the direction of travel
(right) with a wrench (SW 10) to the stop in
the secure position (6).
The safety catch (2) points against the direc-
tion of travel and the slotted spring pin (8) is
visible; the hose pulley is secured against
rolling up.
d3921481
3
8
7
6
2
¾ For double auxiliary hydraulics, turn the
safety catch (4) of the second hose pulley
(5) to the secure position (6) as well.
¾ Disconnect hoses to remove the lift mast.
CAUTION
If the lift mast is extended with the roll-up protection
closed, the hose lines cannot be damaged (ratchet
effect). However, when the lift mast is then retrac-
ted, the hose lines are no longer rolled up and may
therefore be damaged.
The roll-up protection may only be released once
the lift mast has been refitted (hoses reconnected).
To do so, return the safety catch(es) to the free-
wheel setting (7) (safety catch visible).
Removing the lift mast
NOTE
Specialist knowledge and special tools are
required to remove the lift mast. Contact your
authorised dealer.
Operating Instructions – 394 807 10 01 EN – 07/2011 99
To Next Page
Loading...
