4 Operation
Running-in instructions
Service plan before initial commissioning
Carried
out
9
8
Engine
Fill up with fuel
Check the engine oil level
Checking the coolant level
Regenerate the particle filter
Chassis frame
Tighten wheel fastenings
Check the tyre pressure
Checking the brake system
Check steering system.
Electrics / Electronics
Battery: check condition, acid level and acid density
Hydraulics
Hydraulic system: Check the oil level.
Check lifting system and attachments.
Running-in instructions
The truck can be operated quickly immedi-
ately. Avoid high sustained loads on the work-
ing hydraulics and on the travel drive in the
first 50 hours. The wheel fasteners must be
tightened before the commissioning and after
each wheel change. Then after 100 service
hours minimum. Tighten opposite wheel fas-
teners to a torque of
Front: 425 Nm
Rear: 640 Nm
30 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
