Maintenance 5
Engine
¾ Open the filler cap (1) of the filling opening.
¾ Pour new engine oil into the filling opening
according to the recommendations for
consumables.
Fill quantity with filter chang
e: max. 4.5 l
¾ Using the dipstick (2), check the engine
oil level after adding oil and top up to max.
mark.
¾ Fit filler cap (1) and turn to tighten.
¾ Check the indicator unit (4).
The
Oil display (5) (special equipment) in the
display unit must go out. The oil level will not
be displayed reliably in the display unit until
approx. 10 minutes after the oil is added.
NOTE
After changing the oil and the filter, carry out
an engine test run, checking the oil pressure
display and the tightness of the oil drain plug
and oil filter. For an accurate oil level check,
especially after changing the oil filter, it is
necessary to switch off the engine again and
then carry out an oil level check after approx.
one minute.
Changing the engine oil filter
WARNING
Risk of scalding with hot engine oil!
Wear protective equipment.
ENVIRONMENT NOTE
Observe information regarding working with
consumables.
¾ Open the bonnet.
Operating Instructions – 394 807 10 01 EN – 07/2011 123
To Next Page
Loading...
