2 Safety
Handling consumables
• Risk caused by insufficient maintenance or
testing,
• Risk caused by using the wrong consum-
ables.
Stability
Stability is guaranteed if your industrial truck is
used according to its intended purpose.
Stability will not be guaranteed in the event of:
• cornering at excessive sp
eeds,
• moving with the load raised,
• moving with a load that is protruding to the
side (e.g. sideshift),
• turning and driving diagonally across
descents or ascents,
• driving on descents or asc
ents with the load
on the downhill side,
• loads that are too wide,
• driving with a swinging load,
• ramp edges or steps.
In the case of tip-over
• Stay buckled up
•Don’tjump
• Hold on tight
•Bracefeet
• Lean away
The stability of your industrial truck is ensured
if used properly and as intended. Should the
industrial truck tip over during an unapproved
application or due to incorrect operation,
always follow the instructions depicted above.
Handling con
sumables
ENVIRONMENT NOTE
Consumables must be handled properly
and in accordance with the manufacturer’s
instructions.
• Consumables should only be stored in
containers complying with applicable
regulations and at the locations stipulated.
• Do not brin
g flammable consumables into
contact wi
th hot objects or a naked flame.
• When topping up consumables, use only
clean containers.
• Observe the manufacturer’s instructions
relating to safety and disposal.
• Avoid spill
ing.
• Remove any spilled fluid immediately with a
suitable binder and dispose of it according
to applicable regulations.
• Old and contaminated operating materials
should be disposed of according to the
regulations.
• Comply wit
h the statutory provisions.
• Before performing greasing, filter changes
or any work on the hydraulic system,
12 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
