4 Operation
Special equipment
¾ Press the push button (2) at the front
left-hand side of the armrest for longer than
2 seconds.
The tilt angle is now permanently stored. As
confirmation, a double acoustic signal sounds
from the display unit and the light in the button
(2) flashes briefly several times.
The lift mast tilt angle is st
ored in relation to
the truck. The lift mast tilt
angle in relation to
the ground depends on a varie
ty of influenc-
ing factors, such as the tyre
wear, the tyre
pressure of pneumatic tyres
, the load, and the
unevenness and gradient of t
he ground.
Operation
NOTE
The lift mast positionin
g function is designed to
aid the driver and is pure
ly a comfort feature.
The responsibility and c
ontrol for activating
the required mast positi
on always lie with the
driver.
¾ Briefly press button (2) at the front left-hand
side of the armrest. The lamp in the button
lights up and the lift mast positioning
detection is switched on.
¾ Operate the joystick and move to the stored
tilt angle. (For safety reasons, tilting is
permitted only in the direction of the stored
tilt angle, and must be reactivated with each
lift mast positioning).
When the stored lift m
ast position has been
reached, the lift mas
t remains stationary and
an acoustic signal so
unds in the display unit.
¾ Release the joystick or press button (2)
again briefly. The light in the push button
goes out, and the lift mast positioning is
switched off.
¾ The lift mast can now be operated normally
using the joystick.
¾ Briefly press push bu
tton (2) again. Lift mast
position identifica
tion is switched on again.
90 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
