5 Maintenance
Engine
¾ Check that the pointer (5) is positioned
centrally in front of the gap in the baseplate.
¾ To readjust or change the toothed belt,
please contact your authorised dealer
¾ Check the water pump gear (2) for wear.
¾ Place a knife edge (1) on the tooth (4) and
use a feeler gauge to establish the thinning
(3) over the length of the tooth.
If the wastage is m
ore than 0.3 mm the coolant
pump together wit
h the crankshaft pinion gear
and the toothed be
lt must be exchanged.
Please contact yo
ur authorised dealer.
¾ Refit the engine cover.
¾ Refit the side maintenance cover.
138 Operating Instructions – 394 807 10 01 EN – 07/2011
To Next Page
Loading...
