Linde H50D - Page 295

Circuit diagrams 7
Wiring diagram
Arrangement
I Linde Forklift Data Management (LFM)
II LPG volume display for volumetric filling
(LPG version only)
III LPG residual volume display (only with LPG
version)
Legend
6A1 Truck data acquisition unit (FDE), 488–502
:1 − Terminal 30
:2 − Terminal 15
:3 − Earth
:4 − Free input
:5 − Load sensor
:6 − Free output
:7 − Terminal 50
:8 − Starter relay
6A2 Linde Forklift Data Management online
module, 505-510
:4 − Earth
B1 Tank transmitter (volumetric filling), 545
6B2 Load sensor, 512-516
:1 − Terminal 15
:2 − Signal
:3 − Earth
F15 5 A fuse, 499
6F1 Fuse 5 A, 497
K2 Start relay, 482–485
S6 LPG residual volume switch, 550
6W1 Antenna (Linde Forklift Data Management
online module), 510
X6 Five-pin plug connector (for main harness),
545, 550
X10 18-pin plug connector (for basic equipment),
499
6X5 3-pin plug connector (transfer to FDE), 497,
499
6X9 4-pin plug connector (Linde Forklift Data
Management online module), 505-508
Wire colours
BK Black
BN Brown
BU Blue
GN Green
GY Grey
OG Orange
RD Red
VT Violet
WH White
YE Yellow
The number in front of the wire colour refers
to the wire cross-section.
Wires with unspecified cross-section = 0.75
mm
2
Notes
(a) For generator G1:B+
(b) For ignition and starting switch S1:50
(c) For starter motor M1:50a
(d) For brake pedal switch X2:3
(e) Wiring diagram basic equipment (only with
LPG version)
Operating Instructions – 394 807 10 01 EN – 07/2011 283