Linde H50D - Page 303

Circuit diagrams 7
Wiring diagram
Arrangement
I Lighting
II Direction indicator and hazard warning
system
III Brake light
Legend
5E9 10 W left licence plate lamp, 822
5E10 10 W right licence plate lamp, 824
5E11 55 W left dipped beam, 802
5E12 55 W right dipped beam, 804
5E13 5 W front left sidelight, 807
5E14 5 W front right sidelight, 814
5E15 0.5 W rear left sidelight, 812
5E16 0.5 W rear right sidelight, 819
5E23 5 W left side light (only available with twin
tyres), 809
5E24 5 W right side light (only available with twin
tyres), 817
5F5 15 A fuse (lighting terminal 15), 830
5F6 10 A fuse (lighting terminal 30), 835
5F7 5 A fuse (brake light), 849
5F8 7.5 A fuse (left headlight), 802
5F9 7.5 A fuse (right headlight), 804
5F10 5 A fuse (left sidelight), 807
5F11 5 A fuse (right sidelight), 814
5H1 21 W front left direction indicator, 830
5H2 21 W front right direction indicator, 833
5H3 3 W rear left direction indicator, 828
5H4 3 W rear right direction indicator, 836
5H10 2 W direction indicator light, 839
5H20 3 W right brake light, 849
5H21 3 W left brake light, 852
5K2 Brake light relay, 847–849
5N1 Flasher unit, 828–841
5S11 Light switch, 802–808
5S12 Warning light switch, 833–839
5S13 Turn indicator switch, 829–831
X10 18-pin plug connector (for basic equipment),
847
5X1 12-pin plug connector (overhead guard
lighting), 802–839
5X2 6-pin plug connector (rear lighting), 812–849
5X3 2-pin plug connector (transfer to reversing
signal), 841
5X7 6-pin plug connector (left headlight), 802,
807, 830
5X8 6-pin plug connector (right headlight), 804,
814, 833
5X10 2-pin plug connector (licence plate lighting),
822
5X12 4-pin plug connector (right rear light), 819,
836, 849
5X13 4-pin plug connector (left rear light), 812,
828, 851
5X16 2-pin plug connector (licence plate lamp),
822
5X18 2-pin plug connector (right side light), 817
5X19 2-pin plug connector (left side light), 809
Wire colours
BK Black
BN Brown
BU Blue
GN Green
GY Grey
OG Orange
RD Red
VT Violet
WH White
YE Yellow
The number in front of the wire colour refers
to the wire cross-section.
Wires with unspecified cross-section = 0.75
mm
2
Notes
(a) For electronic controller (N1:K51)
Operating Instructions – 394 807 10 01 EN – 07/2011 291