Circuit diagrams 7
Wiring diagram
Arrangement
I Two single levers for lifting/lowering and
tilting
II One single lever for single auxiliary hy-
draulics
III Two single levers for single and double
auxiliary hydraulics
Legend
2B1.1 Joystick for lifting/lowering, 885–887
:1 — 5 V
:3 — Lifting/lowering reference
:5 — Lifting/lowering
:6 — 0 V
2B1.2 Joystick for tilting, 889–892
:1 — 5 V
:3 — Tilting forwards/backwards
:5 — Tilting forwards/backwards reference
:6 — 0 V
2B2.1 Joystick for 1st auxiliary hydraulics (single
auxiliary hydraulics), 902–905, 915–918
:1 — 5 V
:3 — Auxiliary 1 reference
:5 — Auxiliary 1
:6 — 0 V
2B2.2 Joystick for 2nd auxiliary hydraulics (double
auxiliary hydraulics), 920–923
:1 — 5 V
:3 — Auxiliary 2
:5 — Auxiliary 2 reference
:6 — 0 V
N1 Electronic LHC controller, 881–925
:A06 — GND sensor, lift
:A22 — Tilting forwards/backwards
:A23 — Lifting/lowering
:A25 — Auxiliary 1
:A38 — Auxiliary 2
:K21 — Tilting forwards/backwards refer-
ence
:K26 — Auxiliary 2 reference
:K42 — Lifting/lowering reference
:K44 — Auxiliary 1 reference
:K93 — 5 V sensor, lift
2X20 6-pin plug connector, 886–918
2x21 6-pin plug connector, 886–918
2x22 6-pin plug connector, 891, 892, 922, 923
Wire colours
BK Black
BN Brown
BU Blue
GN Green
GY Grey
OG Orange
RD Red
VT Violet
WH White
YE Yellow
The number in front of the wire colour refers
to the wire cross-section.
Wires with unspecified cross-section = 0.75
mm
2
Operating Instructions – 394 807 10 01 EN – 07/2011 293
To Next Page
Loading...
